Harman INFINITY KAPPA 6 Manual De Propietario página 6

Place the tweeter in the mounting location, then turn each setscrew clockwise to tighten mounting brackets. Use caution so
as not to overtighten. Snap the included outer ring over the mounting bracket to hide the setscrews.
Specifications
Continuous power
handling
Peak power handling
Frequency response
Nominal impedance
Sensitivity
External diameter
Mounting cutout diameter
Total depth
Mounting depth
EN
*NOTE: Because of the woofer's low impedance, do not wire two or more in parallel to an amplifier; doing so can result in
overheating and damage to the amplifier.
Kappa 6
100W
300W
40Hz – 25kHz
3 Ohms*
92dB
7-15/32" (189.4mm)
5-23/32" (144.8mm)
3-21/32" (92.5mm)
2-9/16" (65mm)
HARMAN International Industries,
Incorporated 8500 Balboa Boulevard,
Northridge, CA 91329 USA
www.infinityspeakers.com
Kappa 8
200W
500W
30Hz – 22kHz
3 Ohms*
92dB
9-1/2" (241mm)
Woofer: 7" (177.4mm)
Tweeter bracket: 4-9/16"
(115.9mm)
4-9/32" (108.1mm)
3-3/16" (80.5mm)
© 2018 HARMAN International Industries, Incorporated. All rights reserved.
Infinity is a trademark of HARMAN International Industries, Incorporated,
registered in the United States and/or other countries. Features, specifications
and appearance are subject to change without notice.
Kappa 10
300W
900W
20Hz – 2kHz
2 or 4 Ohms (use
switch to select)
89dB
11-5/8" (295mm)
9-9/16" (235.6mm)
6-13/32"
(162.4mm)
4-7/8" (123mm)