Installing Oven And Assembling Oven Doors And Bottom Decorative Trim; Installing The Oven - LG WCES6428F Manual Del Usuario

us_main.book.book Page 12 Thursday, December 9, 2021 8:44 AM
12 INSTALLATION
Installing Oven and Assembling
Oven Doors and Bottom Decorative
Trim

Installing the Oven

Install the oven into the cabinet as follows:
1
Use caution when lifting the oven and wear
gloves to protect hands from any sharp
edges.
2
Use two or more people to lift or move the
oven into the cabinet opening.
• Loop (do not tie) a 36" (91 cm) string around
the conduit before the oven is slid into
place. Lay the string over the top of the
oven and use it to keep the conduit from
falling behind the oven.
• Lift oven into cabinet cutout using the oven
opening as a grip. Carefully push against
the oven front frame. Do not push against
outside edges.
• While sliding the oven back, pull the string
so that the conduit lies on the top of the
oven in a natural loop.
• When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on
one end of the loop.
3
Secure the oven.
• Using the mounting holes
side trim as a guide, drill pilot holes for
screws provided. (For securing the oven,
use a minimum of 4 screws, one on each
side in both the upper and lower ovens.)
• Secure the oven to the cabinet with screws
provided. If the cabinet is particle board,
you must use 3/4" particle board screws.
Assembling Oven Doors
1
2
3
4
on the oven
a
5
Bottom vent trim
a
NOTE
• When you install the oven door, be careful not to
bump the bottom vent trim.
• Keep oven vents unobstructed. Replace the
bottom vent trim if it becomes bent or
These may be purchased at any hardware
store.
Firmly grasp both sides of the door at the top.
With the door at the same angle as the
removal position, seat the indentation
the hinge arms into the bottom edge of the
a
hinge slots . The notch in the hinge arms
b
must be fully seated into the bottom edge of
the slots.
Open the door fully. If the door will not open
fully, the indentation is not seated correctly in
the bottom edge of the slots.
Lock the hinge locks , rotating them back
d
toward the slots in the oven frame until they
lock.
Close the oven door.
of
c