Attaching An Alternative Anti-Tip-Device; Attaching An Edge Protection - Bosch B36BT830NS Instrucciones De Instalación

Ocultar thumbs Ver también para B36BT830NS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Attaching an alternative anti-tip-
device
Important note:
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip-device can be attached.
However, ensure that there is no play between the
appliance and the anti-tip-device. If possible, alwa
screw the wooden beam to existing studs on the rear
panel of the installation enclosure.
1.
Saw the wooden beam (cro
to the required length.
Length is equal to the width of the installation
enclosure!
Note:
If the installation enclosure is deeper than the
appliance, select a beam which has a larger
cross section or attach 2 beams.
The beam must cover the appliance by
at least 2" (50.8 mm).
2.
Mark the installation height (lower edge of the b
on the rear panel of th e installation enclosure.
3.
Select screws according
wooden beam: length = min. 2.5 x beam thickness,
diameter #12 or #14.
Note:
Choose the number of screws according to the
installation enclosure width, thereby ensuring that
the beam can be attached securely.
All manuals and user guides at all-guides.com
ys
ss section min. 3" x 4")
eam)
to the thickness of the
4.
Depending to the subsurface:
Locate wall studs in the rear of the installation
enclosure and accordingly transfer their location t
the wooden beam
or
fasten suitable dowel into the rear wall.
5.
Predrill the wooden beam.
6.
Attach the wooden beam to the rear panel of the
installation enclosure.
3.

Attaching an edge protection

To protect the edges of the installation enclosure,
it is recommended to attach edge protection
made of a suitable material.
o
15

Publicidad

Tabla de contenido
loading

Tabla de contenido