Special Installation; Preparing To Connect The Water; Connecting The Water To The Appliance; Adjusting The Door Opening Angle - Bosch B36BT830NS Instrucciones De Instalación

Special installation

Preparing to connect the water

(only for applianc es which require a water connection)
Note:
Turn off the main water tap to prevent damage cause
by leaking water.
1. Attach the water line to the shut-off valve accor
to the instructions supplied by the manufacturer of
the ice maker installation kit.
2. Install the water line.
Always observe the indicated dimensions to prevent
damage to the water line when pushing in the
appliance.

Connecting the water to the appliance

Note:
When bending the water line, do not kink it, otherwise
there is a risk of leaks and water damage
1. Remove the cap from the appliance connection (
2. Bend the water line accord ing to the location of the
connection on the appliance (
3. Push the union nut and seal onto the water line.
4. Push the end of the wate
connection and screw on the union nut (
Tighten hand-tight.
5. Using the open-ended wrench, tighten the union nu
Do not overturn!
6. Push back the water line
as possible ( 4.).
All manuals and user guides at all-guides.com
d
ding
.
1.).
2.).
r line into the appliance
3.).
t.
into the guard tube as far
7. Open the shut-off valve and main water tap.
8. Check the connection on the shut-off valve and on
the appliance for leaks.
9. Close the shut-off valve.

Adjusting the door opening angle

Depending on the installation situation, it may be
necessary to adjust the door opening angle. A door
opening angle of 115° has been set at the factory.
To adjust the door opening angle to 90°:
1. Open door to 90°.
2. Insert the banking pin th rough the boreholes which
are now vertically aligned and drive in with
a hammer.
23