Harman Infinity Reference 6001A Manual De Propietario página 4

IMPORTANT: Disconnect the vehicle's negative (–) battery
terminal before beginning the installation.
• Always wear protective eyewear when using tools.
• Choose a safe mounting location, away from moisture. Check
clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel
lines, or wiring harnesses and that wire routing will not interfere
with the safe vehicle operation. Use caution when drilling or
cutting in the mounting area.
• Choose a location that provides enough air circulation.
• Do not mount the amplifier with the heat sink facing downward,
as this interferes with cooling.
EN
• Mount the amplifier so that it will not be damaged by the feet of
backseat passengers or shifting cargo in the trunk.
WIRING FOR POWER AND GROUND
At amplifier:
+12V
Fuse holder, fuse
18 (46cm)
"
Battery
aftermarket stereo REM out
(used only with low-level signal inputs)
At ground location:
Factory Bolt
Note: Remove any paint
below ring connector
WIRING FOR INPUT SIGNAL
Low-level signals
DC
TURN-ON
MODE
REM
HI2
INPUT HI1
LEVEL
LO
From stereo subwoofer
Note: when using low-level signals and remote turn-on lead, set the
" " switch to "
switch to " ".
REM GND
Chassis ground (–)
Remote turn-on to
Ring Connector
Ground Wire
Star Washer
INPUT
low-level outputs
" and the "
High-level signals
Loosen
Screws
TURN -ON
MODE
INPUT
LEVEL
Stereo front or rear
speaker wires
Note: when using high-level signals, set the "
switch to " " and the "
sound plays, change the "
CONNECTING TWO REFERENCE 10001A
AMPLIFIERS FOR EXTRA POWER
To connect two Reference 10001a amplifiers, use an RCA patch
cable to connect the "PRIMARY OUT" of the primary amplifier to
the "SECONDARY IN" of the secondary amplifier. Set the Primary/
Secondary switch to "PRIMARY" on the primary amplifier, and to
"SECONDARY" on the secondary amplifier.
AMP 1:
PRIMARY
MODE
SECONDARY
AMP 2:
PRIMARY
MODE
SECONDARY
"
Insert Tignten
Wires Screws
INPUT
DC
REM
HI2
HI1
LO
" switch to " ". If no
" switch to "
PRIMARY OUT
SECONDARY IN
PRIMARY OUT
SECONDARY IN
"
".