Use & Maintenance - Zolia Free Chick Manual Del Usuario

This mode is for the automatic opening of the coop door in the evening / at dusk using the light
sensor, as shown below. The number on the left shows the current ambient light level. Press
Sensor
next step.
This mode uses a combination of both Sensor and Timer, when selecting this mode, you will be
Mix
requested to set the default time first, and the screen will display
opener will use the Light Sensor as its primary reference for closing. If it is not dark enough to
close using the Light Sensor, the default time you set will be used instead.
After the closing mode setting is completed, the screen displays SAVE, indicating the end of the setting up
➢
process. After that, the screen will power down in 10 seconds later to save battery.
TIPS
● The screen will always be on when the setting is not completed, and the battery consumption will be high.
● No matter what mode is set, you can open / close the door manually by pressing
● During the setting up process, the battery level icon
progress by looking at this icon.
● The main interface will display the system time and the mode. For example, if the door opening setting is Timer and the
closing is Mix, then the main interface will display both the Timer
USE & MAINTENANCE
❏
The four screws fixing the front panel and control box need to be tightened to prevent water issues.
Installing the device indoors will affect the accuracy of the Sensor and Mix modes.
Frequently lighting up the screen will increase battery drain.
When the door is opening or closing, the following screen will be displayed until it has finished.
During either opening or closing, the opener won't stop automatically. If the door is stuck, the opener will try to clear the problem
three times. If still stuck, error code "E1" appears and the door will stop.
If you'd like to test that the door will open and close using the light sensor, simply choose Sensor mode for both opening and
closing. Hold your hand over the sensor to simulate darkness and the door will close. Remove your hand and the door will open.
After replacing the battery, it's recommended to press
to adjust the flashing number to a desired light level, press
is not displayed. You can judge whether the setting up is in
and the Mix
to open and close the door once to check it is working properly.
to save and enter the
, when this is set, the door
.
icons.
6