Maintenance; Maintenance Schedule - Husqvarna LB 146 Manual De Usuario

3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To set the cutting height
• Press the shaft out and move it to the correct
position for each of the 4 wheels. (Fig. 30)
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
• Make sure that the ignition cable is connected to the
spark plug.
Manual start (LB 146)
1. Stay behind the product.
2. Hold the engine brake handle against the upper
handle. (Fig. 31)
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope until you feel some
resistance.
5. Pull with force to start the engine.
WARNING:
rope around your hand.
Electrical start (LB 246E)
1. Make sure that the battery is charged. Refer to
Battery (LB 246E) on page 13 .
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
287 - 008 - 22.10.2021
Do not set the cutting height
Do not twist the starter

Maintenance

Before you do
Make sure that the air filter
2. Attach the battery to the engine. The battery locks
into position when you hear a click. (Fig. 32)
3. Stay behind the product and hold the engine brake
handle (A) against the upper handle. (Fig. 33)
4. Push and hold the electrical start button (B) for 3-5
seconds. The engine starts.
Note:
If the engine does not start, wait 1 minute
and try to start the product again.
To stop the product
• To stop the engine, release the engine brake handle.
To remove the battery (LB 246E)
To prevent accidental start of the engine, remove the
battery when the product is not in operation.
• Push the lock button (A) and pull the battery straight
out. (Fig. 34)
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass and
dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
inner surface of the cutting cover on page 12 .
CAUTION:
start, remove the battery before you do
maintenance, repairs or clean the product.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 8 .
To clean the
For models with electrical
11