Midea WMT Serie Manual Del Usuario página 12

SLEEP FEATURE:
Press Sleep button to initiate the
sleep mode. In this mode the selected
temperature will increase by 2°F/1
(or 2)°C 30 minutes after the mode
is selected. The temperature will then
increase by another 2°F/1 (or 2)°C after
an additional 30 minutes. This new
temperature will be maintained for 7
hours before it returns to the originally
selected temperature. The Sleep mode
program can be cancelled at any time
during operation by pressing the Sleep
button again.
CHECK FILTER FEATURE:
The Check Filter feature is a reminder
to clean the air filter for a more efficient
operation. The light will illuminate after
250 hours of operation. After cleaning
the filter, press the Filter button to reset
the Check Filter function turning the
light off.
ENERGY SAVER FEATURE:
Pres s Energy Saver button to
initiate this function. This function is
available on COOL, DRY, AUTO (only
AUTO-COOLING and AUTO-FAN) modes.
The fan will continue to run for 3 minutes
after the compressor shuts off. The fan
then cycles on for 2 minutes at 10 minute
intervals until the room temperature
is above the set temperature, at which
time the compressor turns back on and
Cooling resumes.
COMFORTSENSE FEATURE:
The ComfortSense function enables the
remote control to measure the
temperature at its current location. When
using AUTO, COOL, or HEAT functions,
measuring ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
Page 12
This feature can be activated from the
remote control ONLY.
The remote control will send this signal to
the air conditioner every 3 minutes interval
until press the ComfortSense button again.If
the unit does not receive the ComfortSense
signal during any 7 minutes interval, the unit
will beep to indicate the ComfortSense mode
has ended.
TO SELECT THE OPERATING MODE:
To choose the operating mode, press the
Mode button the unit cycles through the
modes, Auto, Cool, Dry, and Fan. The
adjacent indicator light will remain on
once the mode is selected.
The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto (only
Auto-Cooling and Auto-Fan) modes.
To operate on Auto mode:
• The fan speed is automatically controlled
based on the temperature setting and
room temperature and cannot be adjusted.
• The air conditioner will control room
temperature automatically according
to the temperature you've set.
• In this mode, the fan speed cannot be
adjusted, as it's automatically controlled
according to the temperature setting
and room temperature.
To operate on Fan Only:
• Use this function only when cooling is not
desired, such as for room air circulation
or to exhaust stale air (on some models).
(Remember to open the vent during
this function, but keep it closed during
cooling for maximum cooling efficiency.)
You can choose any fan speed you prefer.
• During this function, the display will
show the actual room temperature,
not the set temperature as in the
cooling mode.
• In Fan Only mode, the temperature is
not adjusted.