Changing The Rotational Direction (Reverse); Emptying The Collection Box; Overload Protection; Restart Lock - Grizzly Tools GHS 2842 B Traducción Del Manual De Instrucciones Original

GB
The device will continue to run af-
ter switching off.
Changing the rotational
direction (reverse)
You can change the rotational direction
of the cutting roll (reverse) to remove
jammed material.
1.
1
2. Turn the rotary switch to the left. The
device is now in inching mode.
à jammed material is released.
3. Change the rotational direction again
to continue shredding (see Section
"Operation/switching on/off").

Emptying the collection box

Empty the collection box regularly.
Be aware that the collection box
fills unevenly under the discharge
chute!
1. Turn the device off.
2. Unlock the collection box (see
No. 11), by switching the safety switch
(see , No. 10) to the "OFF" position.
3. Remove the collection box from the
chassis (see
4. Make sure that the area around the
safety switch is free of wood chips be-
fore inserting the collection box again.
5. Put the collection box back on and
move the safety switch up as far as
it will go so that only the green "ON"
field is visible.
84
Slide the lock of
the rotary switch
2
(see , No. 2)
towards the mains
cable.
, No. 9) and empty it.

Overload protection

If the motor is overused e.g. if the cutting
roll is blocked due to branches that are
too thick, the device switches off auto-
matically.

Restart lock

If the device automatically shuts down
due to overuse, it will not restart automati-
cally.
To restart:
1. Allow the engine to cool.
2. Turn the rotary switch (see
to the OFF position.
3. Press the reset button (see
4. Turn the device on again (see "Switch-
ing on and off").

Practical tips

General working instructions

When shredding, maintain
enough distance from the de-
vice, as long branches can re-
bound when fed in.
There is a risk of injury.
,
Wear eye and hearing protection
Wear safety gloves.
• For safety reasons, the device will not
work if the collection box is not in the
correct position (see
• When feeding branches into the de-
vice, hold them until they feed in auto-
matically.
• Be sure to check the infeed speed of
the shredder and do not overload the
device.
, No. 2)
, No. 1).
).