Repair Service; Technical Specifications - Grizzly Tools GHS 2842 B Traducción Del Manual De Instrucciones Original

sure plate, are subject to normal wear
and are not covered by guarantee.
• Guarantee is conditional on adherence
to instructions on cleaning and servic-
ing instructions.
• Damage resulting from material or man-
ufacturing defects shall be remedied by
replacement or repair free of charge.
• Our service centre will also repair
parts not covered by guarantee for a
fee. The service centre will be pleased
to give you a cost estimate.
We can only repair equipment with
sufficient postage and packaging by
the sender.
• We will not accept bulk consign-
ments, express or other special
freight where postage has not been
paid for.
• We will dispose of your equipment free
of charge.

Repair Service

• For a charge, repairs not covered by the
guarantee can be carried out by our ser-
vice branch, which will be happy to issue
a cost estimate for you.
We can handle only equipment that has
been sent with adequate packaging and
postage.
• Attention: Please send your equip-
ment to our service branch in clean
condition and with an indication of the
defect.
Equipment sent carriage forward or
by bulky goods, express or other
special freight will not be accepted.
• We will dispose of your defective devices
free of charge when you send them to
us.

Technical specifications

Low noise roller chopper ..GHS 2842 B
Nominal power intake .......2800 W
Nominal voltage .........
Safety class .......................................
Degree of protection .........................IP24
Branch thickness ................Max 42 mm**
Collector box content ............. Approx 60 l
Weight ............................................ 22 kg
Sound pressure level (L
................................. 83 dB(A); K
Sound power level
Measured (L )
WA
..........................96,3 dB(A); K
Guaranteed ............................... 99 dB(A)
* Continuous-operation periodic duty (4 min
on - 6 min idle)
** The max. branch thickness that can be
chaffed is dependent on the type of wood
and the quality of the goods being cut.
For hard wood (e.g. oak/beech branches),
the max. branch thickness that can be
chaffed is less than for soft wood (e.g. pine/
spruce wood). For dry or knotted wood, the
cutting thickness may also be less.
Do not exceed the maximum permitted net-
work impedance of 0.28 Ohms at the electri-
cal connection point. The user must ensure
that the device is operated only on a power
supply network that fulfils this requirement.
If necessary, the local power supply compa-
ny can be asked for the system impedance.
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
The stated vibration emission value was
measured in accordance with a standard
GB
(P40)*
220-240 V~; 50 Hz
)
pA
= 3 dB
pA
= 2,4 dB
WA
87
II