Bell FreeFit BE FREE Manual Del Usuario página 3

BATTERY: Install the new battery with the positive (+) pole facing outward (Figure 1). After changing
the battery all settings are erased. Make sure to write down the Odometer value before changing the
battery so you can later re-enter it in the odometer.
Clamp the magnet to a spoke on the right side of the front wheel (Figure 2). Make sure that the magnet
is facing the outside of the wheel so that the flat side of the magnet passes in front of the sensor.
Attach the speedometer sensor to the right fork of the front wheel using the two cable ties provided.
Make sure the metal side of the sensor is facing the wheel. Do not fully secure the cable ties yet, as the
sensor location might require further adjustments (Figure 3).
Adjust the sensor and magnet location so that clearance between the two is no greater than 1/5" (5mm)
(Figure 4). Magnet should pass by the tip of the sensor.
Remove the adhesive tape shield on the back of the bracket and position the bracket on the handlebar of
the bicycle. Fasten the O-ring around the top edge of the bracket and wrap around the underside of the
handlebar and attach to the bottom edge of the bracket. Insert the computer into the mounting bracket
and twist to the right to lock into place.
1
FreeFit_Manual4.indd 3
2 3
Sensor
or
Magnet
INSTALLATION
4
Magnet Magnet
Bicycle fork
5mm
Sensor
Sensor
3
Top View Top View
9/14/05 12:37:11 PM