TallyGenicom 3860 Guía De Referencia Rápida página 24

Make sure the exit rollers engage the form.
Exit Roller
Line Registration on the First Form
If a form did not load.
If a form is loaded, the fault light should be out.
3860/80 Quick Reference Guide
All manuals and user guides at all-guides.com
Print lines may be skewed if the exit rollers do not engage the edges of
the form. Open the top cover and look at the form. If the exit rollers do
not engage the edges of the form, press the PARK/PATH key to park the
form, and pull the locking levers on both tractors forward. Adjust the
paper position so that the left edge of the paper lines up with "0" on the
position guide label behind the home-position tractor. Lock both
tractors.
Exit Rollers Engagement
Precise line registration depends on the form being fully engaged by the
exit rollers. The printer is not guaranteed to hold specified vertical line
registration for the first inch of the first form.
Check the paper path selection. Make sure that the form is loaded in the
tractors that correspond to the paper path selection. If paper is jammed,
take the paper out of the tractors and pull the jammed paper out of the
printer from the tractor side and try again with a fresh form.
If it is not, press the CLEAR key. When the printer is shipped, it is
configured so that a paper-out fault is automatically cleared when a form
is loaded. There is a software option that can be set requiring the CLEAR
key to be pressed to clear the fault, see Chapter 2 of the 3860/80 User's
Manual.
Exit Rollers
Foam
23