Connecting The Printer To A Host System; Attach To A Data Source - TallyGenicom 3860 Guía De Referencia Rápida

Connecting the Printer to a Host System

Attach to a Data Source

When connecting interface cables, turn the printer and data source
off to avoid potential damage.
Connect the cable.
Turn the data source and printer on.
30
All manuals and user guides at all-guides.com
Specific instructions for connection to an SCS or IPDS data source can
be found in the 3972 SCS Guide and 3974 IPDS Guides.
The printer is shipped with auto switching of interfaces enabled. Serial
and parallel interfaces are standard, see Chapter 2 of the 3860/80 User's
Manual.
CENTRONICS/IBM parallel and RS-232 serial printer cables are
available from any computer store. The cables must be rated FCC Class
B in order for the system to meet legal radio frequency interference
limits. The cables should have a braided shield to provide best immunity
from electrostatic discharge.
Serial Interface Connector
Install the cable and tighten cable connector screws or, when using the
parallel interface, secure the cable to the printer with the bail wires on the
printer connector.
To be safe, do it in that order.
WARNING:
Parallel Interface Connector
GEK-01054