Adjusting The Timer; Locking The Controls - Brandt TI1000B Manual Del Usuario

2.3 Switching on: Press the start/stop button
for the cooking zone you want to use (2.3.1 and
2.3.2).
A flashing 0 and a beep indicate that the zone is
on. You can then choose the desired power level. If
you do not select a power level, the cooking zone
will automatically turn itself off.
Switching off: Press and hold the start/stop button
for the cooking zone you want to switch off (2.3.1
and 2.3.2).
2.4 Adjusting the power: Press the "+" or "-" but-
ton to adjust your power level from 1 to P (maxi-
mum power = booster)(2.4.1).
When you switch the hob on, you can move directly
to maximum power "P" by pressing the "-"button.
Adjusting the Cyclic power (2.4.2): Slide your finger
onto the control and move it clockwise to increase
the power level from 1 to P (maximum power) or
move it anti-clockwise to reduce the power level.
Direct access to power: Press the centre part >>:
Press once -> P, Press twice -> 6, Press 3 times -> 3,
and Press 4 times -> P. On switching on, you can
move directly to maximum power "P" by pressing
the "-" button.
Tip: You can adjust your power and timer setting by
one increment every time you press the right or left
side of the circular part.

2.5 Adjusting the timer

A turning timer is available for all of the cooking
zones and is assigned to only one cooking zone at a
time (2.5.1).
To use the timer: Switch the cooking zone on and
adjust the power.
By successively pressing the
choose the cooking zone that
the timer is assigned to. Position the turning symbol
on the chosen cooking zone. Adjust the duration by
pressing " + " or " - ", a dot lights on the power display
to confirm your setting. The timer only operates if
cookware is present on the cooking zone. When you
have finished cooking, the cooking zone turns itself
off and the timer shows 0 and a beep sounds. Press
the "+" or "-" timer buttons to stop this beep.
To change the timer settings: Press the "+" or "-"
timer buttons.
To stop the timer: Simultaneously press the "+" and
"-" timer buttons for a few seconds or press the "-"
timer button until 0 appears.
To change the timer assignment: Stop the timer that
is running by successively pressing the
and assign a new cooking zone in service.
Adjusting the Cyclic timer
A turning timer is available for all of the cooking
zones. All of the timers may be used (2.5.2).
By successively pressing the
choose the cooking zone that the timer is assigned
to.
The timer LEDs may only be assigned to zones in
operation. The timer being displayed is shown with
an extra bright LED.
To use the timer: Switch on the cooking zone and
adjust the power level (2.4.1). Choose the cooking
zone timer LED. Slide your finger over the circular
part until the desired adjustment is obtained for your
cooking time. For long durations, turn the circular
part anti-clockwise to go directly to 99 minutes. The
timer only operates if cookware is present on the
cooking zone. When you have finished cooking, the
cooking zone turns itself off and the timer shows 0
and a beep sounds. Press any button to stop this
beep.
To change the timer settings: Choose your timer,
turn the circular part towards the "+" or "-" part.
To stop the timer: Choose your timer and press and
hold
To directly access the timer: Press the >> button
and the adjustment will be made in ten minute incre-
ments.

2.6 Locking the controls

Your hob has a child safety device which locks the
controls when the hob is not in use (when cleaning for
example) or when it is being used for cooking (to
maintain your settings). Due to safety reasons, only
the "stop" control is always active. It authorises a hea-
ting zone to be switched off even when the hob is
locked.
How do you lock your hob? Maintain pressure on the
lock key until the led on top lights up and a beep
confirms your action.
Hob locked when in operation: The cooking zones in
button, you can
operation display alternates between the power level
and the locked symbol
the power or timer buttons for the zones in operation,
the lock LED lights. It will go out after a few seconds.
Only the "stop" control remains on at all times. For
cooking zones that are not in operation, the
or
the "start/stop" controls. This display will switch off
after a few seconds.
The hob is locked when switched off: The led above
the lock key is switched off. Press this control briefly
to switch on the led. The LED comes on when you
press the "start/stop" control for any cooking zone.
How do you unlock your hob? Press the lock button
until the LED goes out and a double beep is heard to
button confirm your action.
Remember to unlock your hob before attempting to
use it again.
button, you can
.
or
symbols and the LED light when you press
E n g l i s h
. When you press