Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.-
This
monitor
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two "R-6" type batteries into the
battery compartment (A) making sure
that the battery's polarity is correct
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically
if
motionless for 4 minutes.
Important:
components in special containers Fig.2.
FITTING THE MONITOR.-
Fit the brackets (19) onto the back of
the monitor (20), Fig.3, using screws
(45).
Connect terminal (39B), coming out of
the handlebar, to terminal (39C),
coming out of the monitor. Now fit the
monitor onto the handlebar, Fig.4.
Note: For a better view of the monitor,
it can be rotated on the handlebar,
Fig.4.
ELECTRONIC MONITOR.-
To give you greater control over the
uses
two
1.5
the
unit
remains
Deposit
electronic
English
exercise, this electronic unit provides
simultaneous
volt
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
A. SCAN FUNCTION.-
In
SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
ODO, CALORIES, values every 8
seconds.
2. Press the MODE key and this will
cancel the SCAN function.
B. TIME FUNCTION.-
This function counts up or down in
steps
maximum of 99:59 seconds.
Pressing the MODE key for more than
two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
3. Press the SET keys to select the
time.
6
read-outs
mode
the
of
one second,
of
speed,
computer
up to a
Publicidad
