BH Tecnovita Walkone YF30 Manual Del Usuario página 7

4. Begin the exercise and the time
value will begin the countdown, when
it reaches zero it will beep for 12
seconds, advising
selected time has elapsed, the time
value will then start counting upward.
C. DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.01 km/ml, up to a maximum
of 99.99 km/ml. Pressing the MODE
key for more than two seconds will
reset all of the values.
1.Press any key to switch the monitor
on.
2. Press the MODE key to start the
small DIST (DISTANCE)
flashing.
3. Press the SET keys to select the
distance.
4. Begin the exercise and the distance
value will begin the countdown, when
it reaches zero it will beep for 8
seconds, advising
selected distance has been covered,
the distance value will then start
counting upward.
D. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig.1, and remove one of the batteries
to deactivate the monitor, then replace
the battery and the cover (A), Fig.1.
NOTE:
The ODO function will automatically
reset whenever the old batteries are
replaced with new ones.
you that the
window
you that the
E. CALORIE FUNCTION.-
This function counts up or down in
steps of one calorie, up to a maximum
of 999 calories. Pressing the MODE
key for more than two seconds will
reset all of the values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small CAL (CALORIE) window flashing.
3. Press the SET keys to select the
calories.
4. Begin the exercise and the calorie
value will begin the countdown, when
it reaches zero it will beep for 12
seconds, advising
selected calorie
reached, the calorie value will then
start counting upward.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
7
you that the
value has been
for a particular