Metabo BHA 18 LT Manual Original página 12

17026950_1209 BHA 18 LT ENTWURF für SLG.book Seite 12 Donnerstag, 3. Dezember 2009 2:45 14
ENGLISH
ENG
depth stop (1) . Securely tighten the additional
handle at the angle required for the application.
7.2 Carrying strap
If necessary, hang the hook on the Metabo
carrying strap (6) on the eyelet (7). Set the carrying
strap (6) to the desired length.
Carrying:
To prevent unintentional start-up, move the
rotation selector switch (8) to centre posi-
tion (transporting safety device).
Never carry with a tool inserted.
The machine must only be carried with the
Metabo carrying strap (6) across chest and
back (illustration a, page 3). Hold the machine
steady.
The machine must NOT be carried with the
carrying strap (6) around your neck (illustration b,
page 3).
8 Use
8.1 Depth Stop Setting
Release the additional handle (17). Set depth stop
(1) to the desired drilling depth and retighten
additional handle.
8.2 Automatic protection mode
If the machine switches off automatically, the
machine electronics have activated auto-
matic protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger is
released (9) .
Causes and remedies:
1. Battery pack almost flat (the electronics
prevent the battery pack from discharging
totally and avoid irreparable damage).
If one LED is flashing (13) , the battery pack is
almost flat. If necessary, press the (12) button
and check the LEDs (13) to see the charge
level. If the battery pack is almost flat, it must
be recharged.
2. Long continuous overloading of the machine
will activate the temperature cut-out.
Leave the machine or battery pack to cool.
Note: If the battery pack feels very warm, the
pack will cool more quickly in your "AIR
COOLED" charger.
Note: The machine will cool more quickly if you
operate it at idling speed.
12
All manuals and user guides at all-guides.com
3. If the current is too high (for example, if the
8.3
Charge the battery pack before use (11) .
If performance diminishes, recharge the
battery pack.
"Li-Power" li-ion battery packs have a
capacity and signal indicator: (13)
- Press the button (12) , the LEDs indicate the
- If one LED is flashing, the battery pack is almost
8.4
Removal:
Press the battery pack release button (10) and
pull out the battery pack (11) from the back.
Inserting:
Slide in the battery pack (11) until it engages.
8.5
stopped!
Set the rotation selector switch (8).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Middle position: transportation safety
8.6
Switching on, speed: press the trigger (9) . The
Switching off: release the trigger (9) .
8.7
stopped!
machine seizes continuously for long periods),
the machine switches off.
Switch off the machine at the trigger (9) . Then
continue working as normal. Try to prevent the
machine from seizing.
Battery pack
charge level.
flat and must be recharged.
Removing and inserting the battery
pack
Setting the direction of rotation, engag-
ing the transporting safety device
(switch-on lock)
Do not activate the rotation selector switch
(8) unless the motor has completely
device
(Switch-on lock) set
On/Off switch, setting the speed
speed can be changed by pressing in the
trigger.
Operating mode selection
Do not activate the switch button (4)
unless the motor has completely