AmazonBasics B07NDJTS6S Guia De Inicio Rapido

!
WARNING: DO NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. THIS WILL COMPLETELY VOID THE PRODUCT WARRANTY.
No-power to the shredder
 Check power outlet
1) Make sure power cord is plugged
into a functioning 120V standard
household power outlet.
Or, try using a different working
outlet.
 Check power light
2) • Check if the green Power On
• Check the bin is not open.
Shredder is Jammed or runs in "reverse" mode only

Reverse to remove paper
!
Warning: DO NOT USE ANY
SPRAY CANS OR AEROSOLS.
Pull up
1) • Set the control switch to reverse.
• Pull the paper to remove jammed

Turn off shredder
2) • Turn off shredder.
• Apply shredder oil to the feed slot.
• Let oil soak in to paper and
Apply shredder oil and
wait for 30 min
Note: 1. Repeat 1 & 2 steps if
30
Min

Turn on power
3) • Set the power switch to turn on
• Use thick paper stock or a
Use thick paper to push
jam through
4) • Reduce the number of sheets

Reduce sheets to
resume shredding
• Refeed the paper.
Shredder does not feed or shred credit card or small piece
of paper
• Position credit card or small piece of
paper over the credit card section of
the Feeder (center position).
• Try again.
Feed in the center
TROUBLESHOOTING GUIDE
icon is lit.
paper (as much as possible).
machine for 30 minutes.
needed
2. Shredder oil not
included.
shredder.
greeting card to push the jam
through.
being fed (count pages to be sure
not to exceed the maximum sheet
count).
Shredder does not feed or shred paper
 Overheat
Cool down
30
Min
 Overload
Reduce sheets
 Door open
Close door
 Bin full
Empty Bin
 Power light not on
Shredder runs continuously

Unplug power

Clean sensor
Cotton swab
8-Sheet High-Security
Micro-Cut Paper, CD and Credit Card
Shredder with Pullout Basket
B07NDJTS6S
1) If Overheat icon is lit in red, turn
shredder off and let it cool down for
30 minutes. Turn shredder on, check
icon light again, and restart shred-
ding only when icon light is not lit.
2) The Red LED light indicates when
too much paper is inserted. Use the
"Reverse" mode to back up and
reduce number of sheets.
3) If Door Open icon is lit in red,
re-close door until you feel firm click
and Door Open icon is not lit.
4) If Bin Full icon is lit in red, empty bin.
5) If the LED Power On green light is
not on:
Make sure power cord is plugged
into a working outlet.
!
Warning:
DO NOT USE CANNED AIR.
1) Unplug the machine from the wall
socket.
2) • Find the activation sensor in the
center of the feed slot.
• Use a cotton swab to gently wipe
away any dust or debris that has
collected on the sensor.
EN