Environmental Safety; Cleaning And Disposal - DeWalt DC410 Manual De Instrucciones

All manuals and user guides at all-guides.com
USING SANDING BACKING PADS
Choose the proper grit sanding discs for your application. Sanding
discs are available in various grits. Coarse grits yield faster material
removal rates and a rougher finish. Finer grits yield slower material
removal and a smoother finish.
Begin with coarse grit discs for fast, rough material removal.
Move to a medium grit paper and finish with a fine grit disc for
optimal finish.
Coarse
Medium
Fine Finishing
Very Fine Finishing
1. Allow the tool to reach full speed before touching tool to the
work surface.
2. Apply minimum pressure to work surface, allowing the tool to
operate at high speed. Sanding rate is greatest when the tool
operates at high speed.
3. Maintain a 5˚ to 15˚ angle between the
tool and work surface. The sanding disc
should contact approximately one inch of
work surface.
4. Move the tool constantly in a straight line to prevent burning
and swirling of work surface. Allowing the tool to rest on the
work surface without moving, or moving the tool in a circular
motion causes burning and swirling marks on the work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before laying it down.
Precautions To Take When Sanding Paint
1. Sanding of lead based paint is NOT RECOMMENDED due to
the difficulty of controlling the contaminated dust. The greatest
danger of lead poisoning is to children and pregnant women.
2. Since it is difficult to identify whether or not a paint contains lead
PERSONAL SAFETY
1. No children or pregnant women should enter the work area
2. A dust mask or respirator should be worn by all persons enter-
16 - 30 grit
36 - 80 grit
100 - 120 grit
150 - 180 grit
3. NO EATING, DRINKING or SMOKING should be done in the
5˚-15˚

ENVIRONMENTAL SAFETY

1. Paint should be removed in such a manner as to minimize the
2. Areas where paint removal is occurring should be sealed with
3. Sanding should be done in a manner to reduce tracking of paint

CLEANING AND DISPOSAL

1. All surfaces in the work area should be vacuumed and thor-
15
without a chemical analysis, we recommend the following pre-
cautions when sanding any paint:
where the paint sanding is being done until all clean up is
completed.
ing the work area. The filter should be replaced daily or when-
ever the wearer has difficulty breathing.
NOTE: Only those dust masks suitable for working with lead
paint dust and fumes should be used. Ordinary painting masks
do not offer this protection. See your local hardware dealer for
the proper N.I.O.S.H. approved mask.
work area to prevent ingesting contaminated paint particles.
Workers should wash and clean up BEFORE eating, drinking
or smoking. Articles of food, drink, or smoking should not be left
in the work area where dust would settle on them.
amount of dust generated.
plastic sheeting of 4 mils thickness.
dust outside the work area.
oughly cleaned daily for the duration of the sanding project.
Vacuum filter bags should be changed frequently.