Maintenance/Cleaning; Servicing; Cleaning; Storage When Not In Use - Silvercrest SHLF 2000 C1 Manual De Instrucciones E Indicaciones De Seguridad

Cannot control the unit using the remote control (19).

Point the remote control (19) directly at the control panel (1) of the fan heater. This is where the
infrared receiver (15) is. Make sure there are no obstacles between the remote control (19)
and the fan heater.

The distance between the fan heater and the remote control (19) could be too great. Reduce
the distance.

The remote control (19) battery is empty. Insert a new CR2025 3V battery.

10. Maintenance/cleaning

10.1. Servicing

Servicing is required if the fan heater has been damaged in any way, for example, if
liquid has entered the product, if the fan heater has been exposed to rain or moisture, if
the fan heater is not working normally or if the product has been dropped. If you notice
any smoke, unusual noises or strange smells, switch off the fan heater immediately and
remove the mains plug from the mains socket. In these cases, the fan heater should no
longer be used until it has been inspected by authorised service personnel. All repairs must
be carried out by qualified service personnel. Never open the housing on the fan heater.

10.2. Cleaning

DANGER! Unplug the mains plug from the mains socket before you start to clean, there
is the risk of electric shock!
DANGER! Wait until the fan heater has cooled down. Otherwise there is risk of burn
injury!
Clean the fan heater at regular intervals. To clean the fan heater, use a slightly damp cloth. Never
use any solvents or cleaners that may damage the plastic.
If the air inlet grille (6) or the air outlet grille (2) of the fan heater get dirty, you can also clean them
with a vacuum cleaner.

11. Storage when not in use

DANGER! Wait until the fan heater has cooled down. Otherwise there is risk of burns or
fire!
If the fan heater is to be left unused for a long period of time, unplug the power cable (9) from the
mains socket. You can wind the power cable (9) into coils and tie it together with the Velcro on the
power cable (9). Keep the fan heater in a clean, dry place away from direct sunlight.
SilverCrest SHLF 2000 C1
English - 73