Trouble Shooting - Grizzly Tools EHS 600-61 R Traducción Del Manual De Instrucciones Original

GB
Acoustic power level (L
guaranteed ........................... 100 dB (A)
measured ...... 97.2 dB(A); K
Sound pressure level
(L ) ................89.8 dB (A); K
pA
Vibration (a ) at the
h
handle ................. 2.95 m/s
bow handle .......... 1.99 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations named in the declaration of
conformity.
Technical and optical alterations may be
made without notice for the purposes of
improvement. No guarantee can be given
for the accuracy of dimensions, notices
and specifications stated in this manual.
The manufacturer shall therefore not ac-
cept liability for statutory claims arising
from the manual.

Trouble Shooting

Problem
Device does not start
Device runs with
interruptions
Blades become hot
64
)
WA
=2.77 dB
WA
=2.77 dB
pA
; K=1.5 m/s
2
; K=1.5 m/s
2
Possible cause
Mains voltage not on
On/Off switch defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch defective
Blades are blunt
Blades are notched
Too much friction due to
lack of lubrication
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
2
2
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool is
turned off and times when the tool
is turned on but is running idle).
Fault correction
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
Have the blades sharpened or
replaced (Service Centre)
Have the blades checked or
replaced (Service Centre)
Oil the blades