Publicidad
1
L
Sealant/Sellante/Mastic
3
Thin sink /
Thin sink /Thin sink
For Sink Thickness less than 1/2"
For Sink Thickness less than 1/2"
For Sink Thickness less than 1/2"
<1/2" (13mm)
L
H
H
I
J
4
H
L
Use to tighten the
mounting nut (J)
to the spout (L).
Use to tighten the
mounting nut (J)
to the spout (L).
Use to tighten the
mounting nut (J)
to the spout (L).
Turn spout base (L) upside down and apply a
bead of plumbers putty or other sealant on
underside as shown. Rotate spout base back to
the upright position.
Turn spout base (L) upside down and apply a
bead of plumbers putty or other sealant on
underside as shown. Rotate spout base back to
the upright position.
Turn spout base (L) upside down and apply a
bead of plumbers putty or other sealant on
underside as shown. Rotate spout base back to
the upright position.
For sinks thinner than ½" use (H) and (I). Finger tighten the
mounting nut (J).
For sinks thinner than ½" use (H) and (I). Finger tighten the
mounting nut (J).
For sinks thinner than ½" use (H) and (I). Finger tighten the
mounting nut (J).
I
J
For decks thicker than ½" use only (I). Discard (H). Finger tighten the
mounting nut (J).
For decks thicker than ½" use only (I). Discard (H). Finger tighten the
mounting nut (J).
For decks thicker than ½" use only (I). Discard (H). Finger tighten the
mounting nut (J).
5
O
G
J
N
O
2
L
3
L
I
J
Thread lower mounting nuts (F) onto the hot
E
and cold valve bodies (N & G) far enough to
allow for the sink thickness. Place lower
mounting washers (E) onto each valve
F
body (N & G).
Thread lower mounting nuts (F) onto the hot
and cold valve bodies (N & G) far enough to
allow for the sink thickness. Place lower
mounting washers (E) onto each valve
body (N & G).
Thread lower mounting nuts (F) onto the hot
and cold valve bodies (N & G) far enough to
allow for the sink thickness. Place lower
mounting washers (E) onto each valve
body (N & G).
INS1970A - 11/11
Insert the spout base (L) into
center opening on sink with
top threaded shank towards
the back and the tube with
o-rings towards the front.
Insert the spout base (L) into
center opening on sink with
top threaded shank towards
the back and the tube with
o-rings towards the front.
Insert the spout base (L) into
center opening on sink with
top threaded shank towards
the back and the tube with
o-rings towards the front.
Thick sink /
Thick sink /Thick sink
For Sink Thickness more than 1/2"
For Sink Thickness more than 1/2"
For Sink Thickness more than 1/2"
>1/2" (13mm)
I
J
Discard
H
Descarte
Jeter
Publicidad
