Technoline WT 494 Manual De Instrucciones página 12

TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
When alarm 1 or 2 is sounding, the related alarm icon flashes. Press
and reset it to come on the following day. After that both
TO ACTIVATE THE SNOOZE FUNCTION (default snooze duration is 5 minutes)
When alarm is sounding, press
come on again after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
TO SET UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
TO LISTEN TO THE FM RADIO
To turn on the radio, press RADIO/SLEEP once, the display shows "rd" and then the radio
1.
frequency readings in Mhz.
2. Press or
the next clear station.
To adjust the volume, press VOL SET once, the display shows "L05", press
3.
adjust volume from L01 (minimum) to L16 (maximum) .
4. Press RADIO/SLEEP to turn off the radio.
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
AUTO STORE FM STATION IN MEMORY
At FM mode, press and hold
automatically.
TO STORE FM RADIO STATIONS IN MEMORY
This clock radio features a total of 20 preset memories of FM stations. These allow you to preset your
favorite stations and access them quickly.
1. Press RADIO/SLEEP once to turn on the radio. Then tune to a FM radio station you like to
preset.
Press and hold the SET until "P01" flashes. Press SET once to store to "P01".
2.
3. Press or
Press and hold SET until "P02" flashes. Press
4.
once to store to "P02".
5. Repeat Step 2 to 4 to store radio stations to P03 through P20.
6. To remove a pre-stored station, repeat steps 2 to 4 to store another station in its place.
TO SELECT A PRESET RADIO STATION
When the radio is on, press SET once. Then press
to tune the radio to a desired station. Press and hold
to select another station you like to preset (the radio frequency is displayed).
and/or
once, the alarm will be silenced momentarily and
the unit will search station and store in memory
once to select 'P02", then press SET
or repeatedly to select a preset station.
EN4
once to stop the alarm
LED remain on the display.
or to scan for
or to