DJI T30 Guia Del Usuario página 10

3. Make sure all cables are correctly connected and press the power button on the operation
panel of the battery station. The two LEDs and the warning indicator will flash simultaneously.
After powering on, the only lights remaining will be the charging status LEDs, which represent
the batteries currently connected. This indicates that self-diagnosis is complete and the device
is working normally. For more information about how to check if there are any errors during
self-diagnosis, refer to the LEDs and Warning Indicator Description. Alternatively, connect the
battery station to a remote controller and launch the DJI MG or DJI Agras app for more detailed
information about the errors.
4. If no errors are detected during self-diagnosis, the battery station will begin to charge the
batteries. If two batteries are connected simultaneously, the battery station will charge them in
order of their power level, starting from highest to lowest.
Before use, make sure there are no obvious defects on the battery station or batteries (e.g.,
jams, breakages, or short circuits).
DO NOT power the battery station on unless the batteries are correctly connected.
The battery station will automatically adjust the charging current based on the condition
of the batteries being charged. For example, if the battery temperature is below 15° C
(59° F), the charging current will be limited and the charging time will be longer. The
charging time depends on the battery model and battery temperature. The lower the
battery temperature, the longer the charging time will be. The charging temperature range
varies depending on the battery model. Refer to the user guide of the battery to check the
charging temperature range.
LEDs and Warning Indicator Description
During charging, the status LED will blink when the corresponding charging battery is experiencing
an abnormality due to the cable being disconnected, a high or low temperature, overvoltage, or
overcurrent. Once charging is complete, the status LED will be solid green. The battery can be
disconnected from the battery station.
Battery Station Status:
LEDs Warning Indicator
/ Solid green
Solid
Solid yellow
yellow
/ /
Solid Blinks yellow twice
yellow continuously
Charging Indicators:
LED Blinking Pattern
Solid yellow
Blinks green
Power Button
Indicator
The battery station is ready to be activated, or under
/
Solid green
Solid green The battery station is ready to connect to a battery
The battery station logs are being exported and it
/ has stopped charging. Restart the battery station
Warning Sound
/
/
Description
loader stage
Self-diagnosis and power supply of the battery
station are normal
after the logs have been exported
Description
The battery in the corresponding position to the
number is connected and queued to charge
The battery in the corresponding position to the
number is charging
©
2021 DJI All Rights Reserved. 9