Check The Parts - Sony SU-P42T2 Manual De Instrucciones

Check the parts

Name
Main bracket
Stand
Prepare a Phillips screwdriver beforehand.
Install the main bracket
Align the main bracket over the screw holes on the stand. Then fasten
the main bracket to the stand using 10 countersink screws.
Be sure that two or more persons hold the parts during this procedure.
Tighten the 10 countersink screws once again after screwing them temporarily.
Note
Be sure to hold the stand firmly and keep it stable.
Caution
When using an electric screwdriver, set the
torque setting to about 2.45N·m.
Do not use an impact driver. If you use an
impact driver or an electric screwdriver with
the torque setting out of the specified range,
screws may be excessively tightened, which
may damage the screws or product. The
stand may fall and serious injury may result.
6
(GB)
Quantity Name
Countersink screw
1
Securing screw
1 Cable clamper
Countersink
screws
Main bracket
Quantity
10
2
1
Stand