Duronic SADV1 Manual De Instrucciones página 7

Operation
Before use, please check the appliance for damage or faults.
\If you notice any damage or faults on the appliance,
do not use it and contact customer services or your supplier.
1. Turning On
Press the ON/OFF button once of the appliance to turn on.
2. Taking the light
You can read, write, make telephone calls or work while you use the appliance.
When using the appliance, try to maintain the recommended
distance between your eyes and the appliance.
Usage guidelines are as follows:
Distance
60 cm
40 cm
20 cm
In effect, the closer you are to the source of light,
the less time you need to use it.
Note
• Do not look directly into the light continuously.
• Some eye pain or mild headaches may be experienced during initial
sessions but these should pass. If in doubt just lower your treatment times
until you feel comfortable again.
• Do not leave the appliance unattended in the duration.
• Do not touch the appliance in the duration. Let the appliance cool down for
at least 15 minutes before repositioning it.
• Do not block vent holes in the duration.
3. Enjoying light over longer periods
During the darkest period of the year, repeat the treatment for at least 7
consecutive days, or longer, depending on your individual requirements.
4. Switching off
Press the ON/OFF button of the appliance to switch off the light.
Pull the mains plug from the socket.
Let the appliance cool down for at least 15 minutes before storing it away.
Duration
Approx. 2 Hours
Approx. 60 Minutes
Approx. 30 Minutes
12
Cleaning
Warning
Before you clean the appliance,
always switch it off, unplug it and let it cool off.
• Do not touch the appliance with wet hands.
• Clean using a damp cloth, to which you can
apply a little detergent if necessary.
• Do not let water run into the appliance or spill water onto the appliance.
• Cleaning can be done once per month.
Storage
When this appliance is not being used, it should be stored in a dry location out
of reach of children. Do not keep the appliance connected to a power source.
Follow the storage instructions provided in the section
"Technical Specification".
Replacing the lamp tubes
In the event that the lights are faulty, or when they come to end of their life, the
two light tubes can be replaced. NOTE: Do not replace the lamp tubes which
are not provided by the supplier. To do so, proceed as follows:
• Always unplug the appliance and let it cool off.
• For safety reasons, do not remove any components or screws other than
those specified below.
1. Slacken the retaining screws on the back us-
ing a screwdriver, lay the apparatus on its back
and remove the screen.
Note
The four brackets on the front of the screen will
become loose when the screws are slackened.
Take care not to lose them, or the screen cannot
be refitted correctly.
2. Cut the cable ties and bend the tube's two
transparent retaining clips by pulling them gently
upwards.
Note
Cable ties are used for transport protection only.
13