Duronic SADV1 Manual De Instrucciones página 8

3. Carefully pull the tube up over the housing rim
(1) and out of the housing,
then sideways out of the frame (2).
4. When inserting the tube, following these
instructions in reverse order.
Cleaning up a Broken Tube
The light tubes contain a small amount of mercury sealed within the glass
tubing, when a tube breaks in your home, some of this mercury is released as
mercury vapor. To minimize exposure to mercury vapor, we recommend that
users follow the cleanup and disposal steps as follows:
Before Cleanup:
• Have people and pets leave the room and air out the room for 5-10
minutes by opening a window or door to the outdoor environment.
• Shut off the central forced air heating/ air-conditioning system,
if you have one.
• Collect material needed to clean up broken tube, just like: stiff paper or
cardboard, sticky tape, damp paper towels or disposable wet wipes.
During Cleanup:
• Vacuuming is not recommended unless broken glass
remains after all other cleanup steps have been taken.
Vacuuming could spread mercury-containing powder or mercury vapor.
• Be thorough in collecting broken glass and visible powder.
• Place cleanup materials in a sealable container.
After Cleanup:
• Promptly place all bulb debris and cleanup materials outdoors in a trash
container or protected area until materials can be disposed of properly.
Avoid leaving any bulb fragments or cleanup materials indoors.
• If practical, continue to air out the room where the bulb was broken and
leave the heating/air conditioning system shut off for several hours.
14
Disposal
Please note that this appliance is marked with the WEEE
symbol on the left.
This means that this appliance must not be disposed of
together with ordinary household waste, as electrical and
electronic waste must be disposed of separately.
If you have any questions, please contact your local authorities
responsible for waste disposal.
Possible Causes
No Light
Main Power OFF
No Power
Loose Light Tube
Defective Light Tube
One side of the
Light tube at end of life
product is out of
order
Loose Light Tube
FAQ
Solutions
Turn on the switch
The appliance is not cor-
rectly connected to your
power
Re-install the light tube
Change the light tube
Change the light tube
Re-install the light tube
15