Sony SU-LW1 Manual De Instrucciones página 16

Step 6: Install the display on the Plate Unit
WARNING
Do not connect the power cord to a wall socket before the installation is completed. If the mains lead is
pinched, a short circuit may occur, causing an electric shock.
Be careful not to stumble over the cables or the display.
1
KLV-26HG2
Rear of the display
KDL-L32MRX1/KLV-L32MRX1/KLV-30MR1
Rear of the display
KLV-L32M1
Rear of the display
16
(GB)
The supplied screws
(+PSW5 × L16)
Mounting Hook Units
Soft cloth
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
Align the holes on the Mounting
Hook Units with the corresponding
holes on the rear of the display.
Secure them to the display using
four screws.
For the KLV-26HG2, use the screws supplied (+PSW5
× L16). For the KDL-L32MRX1, the KLV-L32MRX1,
the KLV-30MR1, and the KLV-L32M1 use the screws
you removed in Step 5.
Notes
• Lay the display face down on a soft cloth.
• When using an electric screwdriver to tighten the
screws, the torque must be approx. 2 N m.
•