Publicidad
Idiomas disponibles
Idiomas disponibles
Universal Flaring Tool, adjustable 4 - 16 mm
COMPONENTS
1 Spindle with butterfly handle
2 Clamping spindle
3 Flaring element with spindle
4 Flaring pin
5 Clamping element
INTENDED USE
This tool creates 90° flares for aluminium and copper pipes with a diameter of
4.7 - 16 mm (3/16" - 5/8").
SAFETY INFORMATION
• Before using, check all components for damage.
• Do not use the tool if it is damaged.
• Keep children away from the work area. Never let children play with the tool or its packaging
• Only use this tool for tasks for which it is intended.
• Tighten the clamping spindle sufficiently tight. If the clamping spindle is not tightened sufficiently,
the pipe in the clamping element can slip during the flaring process. A clean flare will not be
possible.
1. Turn the clamping spindle (2) counter-clockwise. The
clamping element (5) must be opened sufficiently for the
pipe diameter.
2. Slide the pipe through the clamping element (5) and make
sure that the pipe protrudes sufficiently.
3. Clamp the pipe by turning the clamping spindle (2)
clockwise.
4. Turn the spindle of the flaring element (1) until the flaring
pin (4) is above the end of the pipe.
5. Using the clamping element (5), lock the flaring element (3)
by turning it 45° clockwise.
6. Turn the spindle on the butterfly handle (1) clockwise until
the 90° flare is produced.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 360
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
