• wait for the complete sequence of 5 automatic wash-
ing cycles to be completed (about 1 minute);
• at the end of the first washing cycle, indicated by the
led flashing on button 2
carrier from the unit;
• start the rinsing cycle pressing button 2
of buttons 3
and 4
• wait for the complete automatic rinsing cycle to end
(about 1 minute);
• at the end of the rinsing cycle the machine is ready
for normal use.
In the version with Autosteamer use the
keyboard.
Use the 2
button of the group where wants to wash.
Should the electrical power be cut off during a washing or rinsing
stage, when switched on, the machine will propose again the
washing of the unit using the led of 2
The operation to eliminate the possible presence of residual
detergent in the unit must be carried out again.
8.5.4 Perforated disk cleaning
Weekly perform the cleaning of the perforated disk
in the following way:
• Remove the seal (1) by
levering it with a screw-
driver, being careful not
to damage it;
• remove the perforated
disk (2) and wash it with
hot water;
• place the perforated disk
and seal back to the origi-
nal position.
46
, remove the blind filter
(flashing
;
button any
button.
2
1
8.5.5 Unit and filter holder spray nozzle cleaning
Clean daily the unit and filter holder spray nozzles
with brush provided.
Thoroughly clean the inside of the coupling ring and
filter holder, as well as the edge and the wings of the
filter holder, so as to eliminate any accumulated coffee
residues..
Use the special toothbrush supplied (see Spare Parts Catalogue).
8.5.6 Steam nozzle/autosteamer cleaning
Clean the steam spout once a week as follows:
• Immerse the spout in a jug with
water and a specific detergent
according to manufacturer's in-
structions;
• heat the solution with the steam
of the spout;
• let the spout cool off keeping it
immersed in the solution for at least 5 minutes to
allow the detergent to rise inside the spout by cool-
ing effect;
• repeat the operation 2 or 3 times until milk is deliv-
ered.
User manual