Bs128Hdr; Adjusting The Vertical Bandsaw Blade Guide For Clippings - HOLZMANN MASCHINEN BS 115 Manual De Instrucciones

14.4 BS128HDR

14.4.1 Adjusting the vertical bandsaw blade guide for clippings

Slightly loosen the left bandsaw blade
guide with the screw for fixation.
The tolerance by lowering the bandsaw blade guide leveling on bearing roll on the bandsaw blade
to zero.
Slightly loosen the nuts on either side
guide rollers with a wrench SW17.
After both bearing rollers are adjusted free of play, the two nuts tighten up the leadership roles.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
With a wrench SW 12 is with the help of the
eccentric bearing roller according to externally or
internally displaced.
Repeat on both sides of the process until no play
between the bearing rollers.
The bandsaw blade should be centered on the upper
bearing role.
CAUTION: The two lower side rollers do not clamp!
50
BS115 / BS128HDR