Bs115; Select The Saw Blade Speed - HOLZMANN MASCHINEN BS 115 Manual De Instrucciones

Perform all machine settings with the machine being
Checks to carry out before each workshift:
•
•
•
•
•
•
•
•
Checks to carry out before each cut:
•
•
•
•
•
•
•
•

14.2 BS115

14.2.1 Select the saw blade speed

The saw blade is driven via a
belt drive. Adjust the saw blade
speed at the material to be cut.
Select the feed according to the
following table.
Material
Stainless Steel
Stainless Steel ®
Tool steel
Alloy steel
Bearing bronze
Structural steel
iron
mild steel
Thomas steel
Brass
Aluminium
HOLZMANN MASCHINEN GmbH
disconnected from the power supply!
General technical condition of the machine
Safety equipment available and in working order
Check sawband for wear and replace if necessary
Moving parts are not blocked
All the components for correct fit and function, especially the screws
on the blade guard and lever control!
All the tools for service / maintenance from the machine.
Set the blade guard as close as possible to the workpiece.
Splash guard
Angle set correctly?
Vice adequately fixed?
Make sure that the material to be processed is fixed properly in the
vice.
Ensure that the coolant circulates properly.
Running direction of saw blade.
Never switch the machine on while pressing the blade against
the material!
Wait until the sawband has reached full speed – then
performing the cut!
Always support long overhanging workpieces additionally
Motor pulley
speed
(m/min)
Motor pulley
20
29
50
www.holzmann-maschinen.at
N O T I C E
Belt position
Drive pulley
A D
B E
C F
Drive pulley
Saw band
Bi-Metal
Bi-Metal
HSS
44
BS115 / BS128HDR