LUND LN86521216 Manual Del Usuario página 2

LIGHT BAR INSTALLATION:
1. Remove light bar from box and screw bolts and washers into each end.
2. Slide bolts into crossbeam brackets with the washers on the outside of the bracket, and tighten using
the supplied allen key.
BULL BAR INSTALLATION:
1. Determine if the vehicle is equipped with tow hooks
Vehicles with Factory Tow Hooks
a. Remove each tow hook by removing the front bolt and rear bolt, (Figure 2)
b. Select the driver side Frame Bracket. Position the Bracket up to the bottom of the frame. Use
supplied hardware(10-1.5mm x 55mm Hex Bolt (2), 12mm Lock Washer (2) and 12mm Flat
Washer(2) to attach the Bracket to the bottom of the frame, (Figure 3).
c. Repeat to install the passenger side Frame Bracket.
Fig 2
(Fig 3) Install Frame Bracket
Page 2 of 4
I-Sheet Number I-20260 Rev.A
REVOLUTION BULL BAR
2016-17 NISSAN TITAN XD
05/11/17