LUND LN86521216 Manual Del Usuario página 3

2. Next, carefully unwrap the Bull Bar. Select the driver side Bull Bar Mounting Bracket, (Figure 4). Attach
the Bracket to the end of the Bull Bar with (2) Bolt assembly (Figure 5). Center the mounting flange on
the Bracket with the end of the tube on the Bull Bar. Snug but do not tighten hardware. Repeat this
Step to install the passenger side Mounting Bracket.
(Fig 4) Driver side
Mounting Bracket
3. With assistance, line up the mounting tabs on the Bull Bar with the inside of the (2) previously installed
Frame Mounting Brackets. Bolt the Bull Bar to the Brackets with the included (4) 12mm x 35mm Hex
Bolts, (8) 12mm Flat Washers, (4) 12mm Nylon Lock Nuts, (Figure 6). Snug but do not tighten
hardware at this time.
Fig 6
Page 3 of 4
I-Sheet Number I-20260 Rev.A
REVOLUTION BULL BAR
2016-17 NISSAN TITAN XD
Bolt
Fig 5
Assembly
(2) 12mm x 35mm Hex Bolts
(2) 12mm Flat Washers
(2) 12mm Nuts
05/11/17