Makita DPT350 Manual De Instrucciones página 8

011940
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Hex wrench storage
014779
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Driving pin nails
WARNING:
Before pulling the trigger, always make sure that the
•
opening that pin-nails are fired contacts material to be
fastened. Just pulling the trigger fires pin nails.
Misfiring may cause personal injuries.
1
014780
Place flat the opening of the tool that pin-nails are fired
on the material to be fastened and hold the tool firmly
against the material. Then pull the lever and then pull
the trigger fully to drive the pin nail. The grip is shaped
so that the tool head can be held down securely with
index finger and thumb. After driving a pin-nail, be sure
to release the trigger fully.
1. Groove
1
2. Hook
3. Screw
2
3
1. Hex wrench
1
1. Trigger
2. Material to be
fastened
2
014781
When the head of driven pin-nail remains above the
surface of the material, drive the pin-nail while holding
the pin nailer head firmly.
NOTE:
When the trigger is pulled after a quick trigger
•
action, the nailer may do nothing but operates
momentarily and may not fire pin nails. This is not
a trouble. At this time, release the trigger once,
pull it again and the pin nails can be fired.
Using the pin nailer continuously with the head of
•
fired pin nails remaining above the surface of
material to be fastened may cause damage to the
driver of the pin nailer and nailer jamming etc.
Removing jammed pin nails
WARNING:
Always make sure that the lever is released and
•
the battery cartridge is removed before removing
jammed nails.
1
2
007735
Remove the battery cartridge from the pin nailer.
Take out pin nails that remain inside the magazine.
Loosen bolt (A) and bolt (B) by turning them
approximately two turns using the hex wrench provided
with the pin nailer.
Remove driver guide cover by sliding it.
Remove stuck pin nails, debris, adhesives and
woodchips etc. from the passage for pin nails.
Check the driver guide cover for stuck pin nails or other
foreign matters and then secure it with these two bolts.
8
1. Bolt (B)
2. Driver guide
cover
3. Bolt (A)
3