Amana 12842126 Guía De Uso Y Cuidado página 7

Installation
Leveling
CAUTION
To protect personal property and refrigerator from
damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs, or
other protective material.
• Do not use power tools when performing leveling
procedure.
Notes:
• Complete any required water supply connection
before leveling.
• Some models only have adjustment screws (A).
Materials Needed:
• ⁄ " hex head driver
3
8
• Carpenter's level.
1. Remove toe grille.
• Grasp firmly and pull
outward to unclip.
2. Using hex head driver, turn
the front adjustment screws (A) on each side to
raise or lower the front of the refrigerator (see
illustration below).
A B
C
3. Select models also have rear adjustment screws
(B). Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
4. Using a carpenter's level, make sure front of
5. Turn stabilizing legs
6. Turn adjustment screws
7. If required, correct
B
A
C
refrigerator is " (6 mm) or approximately
1
⁄
4
higher than back of refrigerator and that the
refrigerator is level from side to side.
(C) clockwise until
firmly against floor.
(A) counterclockwise
to allow the full weight
of the refrigerator to
rest on the stabilizing
legs.
rocking of refrigerator
by turning rear
adjustment screw
clockwise to raise
rocking corner. If doors
are uneven, do the following:
• Determine which door needs to be raised.
• Turn front roller adjustment screw (A) clockwise
to raise front corner of door.
• If one refrigerator door has reached the limit of
its adjustment range and doors are still not level,
raise or lower the opposite door by turning roller
adjustment screw clockwise or counterclockwise.
• Check with level to verify 6 mm tilt to the back
for proper door closure.
• If refrigerator is aligned and stable, replace toe
grille.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
bubble
1
⁄
2
Roller Adjustment Screw
Stabilizing
Leg
6