Metabo HPT NR 83A5 Instrucciones Y Manual De Seguridad página 14

English
WARNING
Never use Nailer unless push lever is
operating properly.
Before actually beginning the nailing work, test the Nailer
by using the checklist below. Conduct the tests in the
following order.
If abnormal operation occurs, stop using the Nailer
and contact a metabo HPT authorized service center
immediately.
(1) DISCONNECT AIR HOSE FROM NAILER.
REMOVE ALL NAILS FROM NAILER.
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them.
THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Trigger
Push Lever
(2) REMOVE ALL NAILS FROM NAILER.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE TOOLS TO OPERATE
SWITCH.
Select SINGLE SEQUENTIAL ACTUATION MODE
according to the following steps.
1 Open the change stopper by pushing the bottom of
trigger.
2 Grasp the change rod between two fi ngers (one on
each side of the trigger) and slide it down (Single
Sequential Actuation Mode.)
14
000Book̲NR83A5̲US̲metabo.indb 14 000Book̲NR83A5̲US̲metabo.indb 14
3 Confi rm that the change stopper has completely
returned to original position inside the trigger.
(SINGLE SEQUENTIAL ACTUATION MECHANISM).
(3) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm
Connect the air hose.
(4) Remove the fi nger from the trigger and press the
push lever against the wood.
Do not connect
air hose
Grasp The
Change Rod
2
1
Push The Change stopper
3
Position of
Change Rod
THE NAILER MUST NOT LEAK AIR.
THE NAILER MUST NOT OPERATE.
Do not pull Trigger
Depress Push Lever
).
2
2018/05/22 13:58:55 2018/05/22 13:58:55