Introduction Of Advanced Tuner Operation; Storing And Recalling Broadcast Frequencies; Tuning In Strong Signals - Pioneer DEH-P9600MP Manual De Instrucciones

Section
04 Tuner
Introduction of advanced
tuner operation
1 Function display
Shows the function status.
1 Press OPEN to open the front panel.
2 Press FUNCTION to display the function
names.
Press FUNCTION repeatedly to switch be-
tween the following functions:
BSM (best stations memory)Preset channel
listRegional (regional)Local (local seek
tuning)Program type selection (PTY)
Traffic Announce (traffic announcement
standby)Alternative FREQ (alternative fre-
quencies search)News Interrupt (news
program interruption)
# To return to the frequency display, press
BAND.
# If MW/LW band is selected, you can only se-
lect BSM, preset channel list and Local.
Note
If you do not operate the function within about 30
seconds, the display is automatically returned to
the frequency display.
Storing and recalling
broadcast frequencies
If you press any of the preset tuning buttons
16 you can easily store up to six broadcast
16
En
All manuals and user guides at all-guides.com
1
frequencies for later recall with the touch of a
button.
% When you find a frequency that you
want to store in memory press one of pre-
set tuning buttons 16 and hold until the
preset number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected radio station frequency has been
stored in memory.
The next time you press the same preset tun-
ing button the radio station frequency is re-
called from memory.
Notes
! Up to 18 FM stations, six for each of the three
FM bands, and six MW/LW stations can be
stored in memory.
! You can also use a and b to recall radio sta-
tion frequencies assigned to preset tuning
buttons 16.

Tuning in strong signals

Local seek tuning lets you tune in only those
radio stations with sufficiently strong signals
for good reception.
1 Press FUNCTION to select Local.
Press FUNCTION until Local appears in the
display.
2 Press a to turn local seek tuning on.
Local seek sensitivity (e.g., Level 2) appears in
the display.
3 Press c or d to set the sensitivity.
There are four levels of sensitivity for FM and
two levels for MW/LW:
FM: Level 1Level 2Level 3Level 4
MW/LW: Level 1Level 2