Led Indicators - Tripp-Lite NFI-U05 Manual Del Usuario

Cabling
Connect one end of an RJ45 Ethernet cable (see Optional
Accessories) into the switch's RJ45 Ethernet port. Connect the other
end to a network device. Cat5e cable or above is recommended.
All ports support Fast Ethernet (10/100Base-T), as well as auto-
negotiation and auto MDI/MDI-X to eliminate the need for crossover
cabling.

LED Indicators

PWR (Green)
10/100 (Green)
LNK/ACT
(Green)
Power on by Terminal Block PWR
Illuminated
Terminal Block PWR/DC jack fails
Off
Illuminated
Blinking Data is transmitting/receiving
Off
Illuminated
Blinking Data is transmitting/receiving
Off Port disconnected or link failed
13
or DC jack
or is unavailable
Link speed is 100 Mbps
Link speed is 10 Mbps
Copper port link-up