Grounding The Switch - Tripp-Lite NFI-U05 Manual Del Usuario

DIN-Rail Mounting and Dismounting Instructions
Wall-Mounted Mask (NFI-U08-1 Only)
1. Remove the DIN rail kit before wall mounting.
2. Mount the switch by using mounting holes on the wall at the
appropriate places.
3. The switch can be wall mounted either vertically or horizontally.

Grounding the Switch

Grounding and wire routing help limit the effects of line noise caused
by electromagnetic interference (EMI). Run the ground connection from
the ground screw to the grounding surface, then connect the ground
connection from the terminal block to the grounding surface prior to
connecting devices.
ATTENTION: This switch is intended for mounting on a well-grounded
surface, such as a metal panel.
Mounting bracket for
NFI-U08-1
9