Wiring Requirements - Tripp-Lite NFI-U05 Manual Del Usuario

Wiring Requirements

WARNING: Safety measures should be taken before
connecting the power cable. Turn off the power before
connecting modules or wires. The correct power supply voltage
is listed on the product label. Check the voltage of your power
source to make sure you are using the correct voltage. DO NOT
use a voltage greater than what is specified on the product
label.
• Use minimum 24AWG power cable wire when connecting.
• Use a Power Supply that provides a Limited Power Source.
These power supply are generally marked LPS.
• Be sure to observe the polarity when connecting. Not
following polarity can damage your unit and void your
warranty.
Please read and follow these guidelines:
• Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
Note: Do not run signal or communications wiring and power wiring through
the same wire conduit. To avoid interference, wires with different signal
characteristics should be routed separately.
• You can use the type of signal transmitted through a wire to determine
which wires should be kept separate. Wiring that shares similar
electrical characteristics can be bundled together.
• You should separate input wiring from output wiring.
• Be advised that you should label the wiring to all devices in the system.
10