Troubleshooting - Royal Dirt Devil M7110 Manual De Instrucciones

All manuals and user guides at all-guides.com
02_M7110_gb.book Seite 33 Freitag, 10. Oktober 2008 10:17 10

5 Troubleshooting

5 Troubleshooting
First check according to the following table if you can solve the problem on your own before
contacting your authorised Royal dealer, Royal service partner or appliance market.
WARNING:
Danger of injury! Never use a defective appliance. Always switch off the appliance and disconnect
it from the mains before starting troubleshooting
power cord".
Problem
The appliance will Plug is not plugged in or the
not start appliance is not switched on.
Socket does not carry any
current.
Power cable is damaged.
Red warning light The dust filter bag is full or
is on. clogged.
Nozzle, telescopic tube or suction
hose are blocked.
The power setting does not suit
the flooring.
The filter is dirty.
Cleaning is The attached nozzle does not fit
unsatisfactory in the flooring.
spite of the
The "carpet/hard floor" switch
appliance working
(Fig. 1/9) is in the wrong position
correctly.
for the particular type of floor.
The appliance Sucked-in objects are obstructing
makes unusual the air stream.
noises.
NOTE:
If you cannot solve the problem by following these instructions, please refer to your authorised
Royal dealer, Royal service partner, your appliance market or Royal customer service ( Page
196, "Royal Appliance Int. GmbH International Service").
Chapter 3.4, "Switching off and retracting
Possible cause
Insert the plug into a mains socket and
switch on the appliance
"Vacuum cleaning".
Test the cylinder vacuum cleaner at another
socket which you are sure carries current.
Have the power cord replaced by the
Royal Appliance Customer Service,
address:
Empty/clean the dust filter bag.
Remove the obstacle. If necessary, use a
long wooden stick (e.g. a broomstick) to do
this.
Set the power to the setting suggested for
the flooring,
cleaning", step 4.
Change/clean the respective filter Chapter
4.4, "Changing the motor protection filter" or
Chapter 4.3, "Changing the hygienic
exhaust filter".
Attach the correct nozzle
"Using further nozzles (accessories)".
Set the "carpet/hard floor" switch to the
correct position for the (Fig. 1/9) particular
type of floor,
cleaning", step 5.
Remove the objects. If necessary, use a
long wooden stick (e.g. a broomstick) to do
this.
Solution
Chapter 3.3,
Page 35, "Warranty".
Chapter 3.3, "Vacuum
Chapter 2.3,
Chapter 3.3, "Vacuum
33