Technical Parameters - YATO YT-82800 Manual Del Usuario

PROPERTIES OF THE TOOL
The impact wrench is a versatile tool, that does not require an external power source, it is portable, designed for the DIY users. It
should be used only for is crewing in and out bolts and nuts with left-hand and right-handed thread, by using a variety of screw-
driver bits. Through the impact mechanism the impact wrench offers much higher torque than a typical cordless screwdriver drill.
Its special advantages would be appreciated by the DIYs who make a variety of assembly and finishing works. A correct, reliable
and safe functioning of the electric tool depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. Together with the product there are provided: the recharge-
able battery and charging station (charger).
Attention! The product of the catalog number: YT-82801 has not been equipped with a rechargeable battery and charging station.

TECHNICAL PARAMETERS

Parameter
Catalogue number
Operating voltage
Rotation (idle)
Impact frequency
Maximum torque
Noise level
- acoustic pressure
- LWA power
Protection grade
Insulation class
Level of vibration (drilling / screwdriveting)
Mass
Tool handle
Battery
Capacity of the battery*
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging**
* only for models equipped with battery and charger
** charging time applies only to the battery with a capacity listed in table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do not
work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours. Elec-
tric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours. Do not allow children
and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
O R I G I N A L
All manuals and user guides at all-guides.com
Unit of measurement
GB
[V]
[min ]
-1
[Nm]
[dB]
[dB]
[m/s ]
2
[kg]
[mm]
[Ah]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82800, YT-82801
18 DC
0 - 3000
0 - 3000
160
82,0 ± 3,0
93,0 ± 3,0
IP20
III
8,15 ± 1,5
1,1
6,3
Li-Ion
2
220 - 240
50 / 60
60
21 DC
2.4
1
11