DeWalt DWS520 Manual De Instrucciones página 8

WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may contribute
to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their defi nitions are as follows:
V .............. volts
Hz ............ hertz
min .......... minutes
....... direct current
............ Class I Construction
................ ................ (grounded)
............ Class II Construction
................ (double insulated)
.../min ..... per minute
IPM .......... impacts per minute
BPM ........ beats per minute
RPM ........ revolutions per
minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage
decrease of more than 10% will cause loss of power and overheating.
D WALT tools are factory tested; if this tool does not operate, check
E
power supply.
A ...........amperes
W ..........watts
........alternating current
........alternating or
.............direct current
n o .........no load speed
n ...........rated speed
.........earthing terminal
..........safety alert
.............symbol
SPM .....strokes per minute
sfpm .....surface feet per
.............minute
6
WARNING: Accessories must be rated for at least the speed
recommended on the tool warning label. Accessories running over
rated speed can fl y apart and cause injury. Accessory ratings must
always be above tool speed as shown on tool nameplate.
WARNING: Avoid contact with the blade teeth to prevent personal
injury.
COMPONENTS (Fig. 1–3, 8)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Plunge trigger O. Outer fl ange
B. On/off switch
C. Main handle Q. Riving knife
D. Shoe R. Riving knife adjustment screws
E. Bevel adjustment knob S. Speed wheel
F. Depth adjustment knobs
G. Depth scale U. Anti-kickback knob
H. Front handle
I. Dust extraction outlet W. Track
J. Track adjuster
K. Blade
L. Lock button
M. Lock lever
N. Blade clamping screw
P. Inner fl ange
T. Cutting indicator
V. Outer guard
X. Bevel scale
Y. Blade position indicators
Z. Hex wrench