Angelcare AC-WSP Manual De Usuario página 6

1.2 - SELECT A LOCATION FOR THE SENSOR PAD
1.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stable surface for the Sensor Pad, you will
need to place a support under it, to ensure correct operation of the system.
This hardboard support should be at least 6 mm thick and should have
minimum dimensions of 33 cm x 33 cm. This support board must be larger
than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except
memory-foam mattresses, hollow frame mattresses and water beds. The
hardboard maintains a constant pressure on the Sensor Pad, enabling it to
detect the baby's movements even when the baby is at the edges of the cot.
Sensor Pad
ADVERTÊNCIA
• The Sensor Pad is not designed for use with adults, children or infants older than 24 months.
• Discontinue used of the Sensor Pad when child is older than 24 months.
Remove Sensor Pad from cot and store for future use.
• BEFORE FIRST TIME USE: To test that the unit is ready for use, refer to instruction
manual on how to test that the installation has been done correctly.
6
All manuals and user guides at all-guides.com
Place the
Camera at least
1 metre from the
2
1) Remove the mattress from the cot.
2) Place the Sensor Pad - Angelcare
3) Replace the mattress.
cot
side up - in the center of the mattress.
It should be centered on the hardboard
if your cot requires a hardboard
support.
Hardboard
® logo