Replacing Filter - GYS GYSMATIC TRUECOLOR GOGGLE 3 Manual De Usuario

Translation of the original instructions
REPLACING BATTERIE

REPLACING FILTER

SYMPTOMS AND SOLUTIONS
The optoelectronic filter does not work.
Filter stays dark after the weld arc is extinguished or when no arc is
present.
Uncontrolled and sparkling switching: The filter lightens and darkens
when welding.
Side of the filter is lighter than the center of viewing area.
GYSMATIC TRUECOLOR GOGGLE 3
The opto-electronic filter requires two 3V lithium battery (CR2032).
Follow the instructions below to change batteries:
- Using the battery remover to take out the battery (D).
- Change the battery and then put them back.
- It is recommended to replace the battery once a year.
CAUTION
- Recycle used lithium batteries. In Europe, batteries are considered as dangerous waste.
- Do not throw in the bin. To drop off only in collection point for used batteries.
Activate the solar charge by exposing the cell to the light between 20 to 30 minutes - Check and
change battery if necessary.
Check that you have selected the 4-8 or 8-13 setting range with the «WELD» button.
Check and clean detectors if needed.
Adjust sensitivity knob to the lower position (level 1). If the welding place is extremely bright, it is
recommended to reduce light level.
Check arc sensors are not blocked from direct access to the arc light. Set the sensitivity level to 5.
It is a natural feature of LCD's, this symptom is not dangerous for the eyes. However for a
maximum comfort, try to keep an view angle at around 90°.
5. Peel off the control panel (E).
6. Loose the screw (F) and take out the filter (G)
assembly from the shell. Tighten the screws (H).
7. Paste the control panel (I).
10
EN