Overview Of The Components - AEG SR 4364 BT Instrucciones De Servicio

English
46
WARNING:
Avoid damage to your hearing with volume that is too high.
CAUTION:
Do not touch the loudspeaker membranes (13) with your
hands or with objects. The membranes can get damaged
that way.

Overview of the Components

1 Telescopic antenna
2 FOLD./10+ button
3 button (increase volume)
4 CD compartment
5 PUSH TO OPEN button (open CD tray)
6 / TUN- button
7 EQ button (equalizer)
8 / M+ / button
9 AUX IN input
10 headphone connection
11 / TUN+ button
12 / M- / ID3 button (Stop / Select preset location / ID3 tag
meta data on/off)
13 Loudspeaker membranes
14 PAIR/STANDBY – Standby indicator lamp /Bluetooth
Pairing
15 IR Infrared sensor for remote control
16 Display
17 MEM/P-MODE button
18 button (reduce volume)
19 USB port
20 / FUNC. button
Reverse (not shown)
AC Mains connection
Underside (not shown)
Battery compartment
Remote control
1 STANDBY/ button (operational readiness)
2 EQ button (equalizer)
3 FM ST/MO button (stereo/mono)
4 DIR button (select album)
5 VOL buttons (volume)
6 TUN+/ button (radio station search upward/ next track)
7 PAIR button (disconnect current Bluetooth connection)
8 button (stop)
9 MEM/P-MODE button (storing/playback mode)
10 button (playback/ pause)
11 TUN-/ button (radio station search downward/ previ-
ous track)
12 MEM./10 buttons ( respectively 10 select tracks/
stored radio stations)
13 ID3 button (ID3 tag Meta data on/off)
14 FUNC. button (function mode)
15 MUTE button (mute)
Start-up of the device/introduction
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Ensure that the voltage is the same as that indicated on
the model identification plate.
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC on the back of the
machine.
NOTE:
If the device is not used for a longer period of time, the
mains plug must be pulled from the socket.
Inserting the Batteries (not supplied)
1. Open the battery compartment lid on the rear.
2. Insert 8 batteries of type UM1/R20 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Batteries may leak and lose battery acid. If the device is
not used for a longer period of time, remove the bat-
teries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Remote control
NOTE:
The lithium cell in the battery compartment of the remote
control was secured with foil for transport. This extends the
battery life. Remove this foil before initial use to operate the
remote control.