Kohler K-142 Manual De Instrucciones página 3

DETERMINE YOUR DRAIN STYLE AND FOLLOW THE
APPROPRIATE INSTALLATION STEPS.
DRAIN (CP AND PB FINISHES)
Remove the protective seal from the
S
flange.
Apply a 1/2" (1.3cm) diameter ring of
S
plumbers putty around the underside
of the flange. Insert the flange into the
bidet drain hole.
Assemble the gasket (tapered side up)
S
and washer to the flange, and partially
thread nut to the flange. Do not fully
tighten the nut at this time.
Install the body washer and body to
S
the flange, and wrench-tighten.
Position the body so the seal hole is
S
facing toward the back of the bidet.
Hand-tighten the nut.
S
Remove any excess plumbers putty.
S
DRAIN (OTHER FINISHES)
Remove the flange from the body.
S
Thread the nut completely onto the
S
body.
Apply a 1/2" (1.3cm) diameter ring of
S
plumbers putty around the underside
of the drain flange.
Insert the drain body up into the
S
underside of the bidet drain hole.
Position the body so the seal hole is
S
facing toward the back of the bidet.
Thread the flange onto the drain body
S
from the topside of the bidet.
Securely hand-tighten the nut from the
S
underside of the bidet.
Remove any excess plumbers putty.
S
Assemble the nylon washer, metal
S
washer, and nut onto the long end of
the rod.
Assemble the nylon washer and
S
rubber washer onto the short end of
the rod.
Kohler Co.
Seal Hole
Flange
Apply Plumbers
Putty
Seal
Hole Body
Metal Washer
Nut
Nylon Washer
Rubber Washer
3
Flange
Apply Plumbers
Putty
Gasket
Washer
Nut
Body Washer
Body
Bidet
Underside
Nut
Nylon Washer
Rod
1010448-2-D