Kohler K-142 Manual De Instrucciones página 7

HOSE CONNECTIONS
Connect the plastic flexible hose from
S
the transfer valve to the shank of the
spray head assembly using thread
sealant.
Connect the braided hoses from the
S
end body valves to the supply tee.
NOTE: Position the hose/supply tee
assembly to avoid interference with the
drain mechanism before tightening.
Connect the other end of the supply
S
tee hose to the transfer valve/vacuum
breaker. Use the gasket at the
connection.
IF THE BIDET IS NOT INSTALLED, INSTALL IT AT THIS TIME. BE
SURE TO FOLLOW ALL INSTRUCTIONS PACKED WITH THE
BIDET.
SUPPLIES AND STOPS
Identify your supply connection type.
S
Connect the supply tubes to the end
body valves and supply stops. (Left is
hot - right is cold.)
Tighten all connections.
S
Kohler Co.
Shank
Apply thread
sealant
Transfer Valve/
Vacuum Breaker
End Body
Valve
Gasket
Union
Nut
HOT
7
Spray Head
Assembly
Plastic
Flexible
Hose
Supply Tee
Compression
COLD
1010448-2-D