Kohler K-142 Manual De Instrucciones página 4

ALL DRAINS
Insert the stopper into the flange.
S
Remove the body nut from the seal
S
hole.
Fit the short end of the rod into the
S
body seal hole and under the stopper
for regular installations; through the
hole for vandal-resistant installations.
Loosely secure in place with the body
S
nut.
Remove and adjust the stopper so the
S
stopper lifts about 3/8" (1cm) when
opened. To adjust, loosen the stopper
nut and shorten or lengthen the
stopper as needed. Re-tighten the
stopper nut.
Hand-tighten the body nut.
S
Apply thread sealant to the tailpiece.
S
Thread the tailpiece into the body and
securely hand-tighten.
Slide the clip and the link onto the rod
S
with the thumb screw facing toward
the back of the bidet.
To move the link to the proper
S
position, squeeze the clip and slide it
along the rod.
Push the rod down (open position).
S
Slide the lift rod through the hole in the
S
lift rod escutcheon and then into the
hole in the link.
Tighten the thumb screw on the link so
S
the lift rod knob is 1/2" (1.3cm) above
the lift rod escutcheon.
1010448-2-D
Body
Nut
Rod
Seal Hole
Apply Thread
Sealant
Thumb
Screw
Clip
Rod
1/2"
(1.3cm)
Thumb
Screw
4
Stopper
Stopper
Nut
Body
Tailpiece
Link
Lift Rod Knob
Lift Rod
Escutcheon
Link
Kohler Co.